$Id: README.error-codes,v 1.1 1999/12/14 14:03:02 fliegl Exp $

This is the documentation of (hopefully) all possible error codes (and
their interpretation) that can be returned from the hostcontroller driver 
and from usbcore.

NOTE:
The USB_ST_* codes are deferred and are only listed for compatibility, new
software should use only -E* instead!



**************************************************************************
*                   Error codes returned by usb_submit_urb               *
**************************************************************************

Non-USB-specific:

USB_ST_NOERROR
0		URB submission went fine

-ENOMEM		no memory for allocation of internal structures	

USB-specific:

-ENODEV		specified USB-device or bus doesn't exist

-ENXIO		specified endpoint doesn't exist on the device

USB_ST_URB_INVALID_ERROR
-EINVAL		a) Invalid transfer type specified (or not supported)
		b) Invalid interrupt interval (0<=n<256)
		c) more than one interrupt packet requested

-EAGAIN		a) specified ISO start frame too early
		b) (using ISO-ASAP) too much scheduled for the future
		   wait some time and try again.

-EFBIG		too much ISO frames requested (currently uhci>900)

-EPIPE		specified pipe-handle is already stalled

-EMSGSIZE	endpoint message size is zero, do interface/alternate setting


**************************************************************************
*                   Error codes returned by in urb->status               *
*                   or in iso_frame_desc[n].status (for ISO)             *
**************************************************************************

USB_ST_NOERROR
0			Transfer completed successfully

USB_ST_URB_KILLED
-ENOENT			URB was canceled by unlink_urb

USB_ST_URB_PENDING
-EINPROGRESS		URB still pending, no results yet
			(actually no error until now;-)

USB_ST_BITSTUFF
USB_ST_INTERNALERROR
-EPROTO			a) bitstuff error
			b) unknown USB error 

USB_ST_CRC
-EILSEQ			CRC mismatch

-EPIPE			a) babble detect
			b) endpoint stalled

USB_ST_BUFFERUNDERRUN
-ENOST			buffer error

USB_ST_NORESPONSE
USB_ST_TIMEOUT
-ETIMEDOUT		transfer timed out, NAK

USB_ST_REMOVED	
-ENODEV			device was removed

USB_ST_SHORT_PACKET
-EREMOTEIO		short packet detected

USB_ST_PARTIAL_ERROR
-EXDEV			ISO transfer only partially completed
			look at individual frame status for details

USB_ST_URB_INVALID_ERROR
-EINVAL			ISO madness, if this happens: Log off and go home

**************************************************************************
*              Error codes returned by usbcore-functions                 *
*           (expect also other submit and transfer status codes)         *
**************************************************************************

usb_register():
USB_ST_NOTSUPPORTED
-EINVAL			error during registering new driver

usb_terminate_bulk():
USB_ST_REMOVED
-ENODEV			urb already removed

usb_get_*/usb_set_*():
			All USB errors (submit/status) can occur